BBC M/T Valve Covers 1/25

A pair of BBC or HEMI valve covers with a filler cap on the end of each one. Contains 2 resin pieces.

Large Tapered Pro Stock Wing 1/25

This wing is fairly large and is straighter along the rear edge than along the front edge. End plates are tapered toward the rear and extend down from the top edge. Measurements: Overall length: 2.15" (at the widest, front, edge) Width at end plates: 1...

Pro Stock/Pro Mod Wing 1/25

This wing has a small arch as viewed from the toop. Has teardrop end plates. Measurements: Overall length: 2.15" Width at end plates: .52" Contains 1 resin piece, 1/25 scale

Altered or Small Wing 1/25

A small wing for any use, but a fuel altered is an example. Has teardrop end plates. Measurements: Length: 1" Width: .62" Contains 1 resin piece, 1/25 scale

Top Fuel Wheel Set 1/25

A set of four Racing Wheels for a TF dragster - front and rear. Features a thin front wheel with a deep rim in order to make sure the timing lights are tripped at the end of the quarter mile. The 2-piece front wheel will accept the 'bicycle tire' found...

Black Coated Hard Line .016", .4mm Dia

This hard line has a glossy black coating over a wire and lends a different look to your build. It holds its shape and can be bent at tight angles without kinking. Equivalent 1:1 size at each scale. 1/25 scale = 3/8"1/16 scale = 1/4"1/12 scale =...

Micro Sol, Setting Solution

Microscale's Micro-Sol is a decal "setting" solution for the most difficult irregular surfaces to be found on models. It allows the decal to drape down onto the surface of the model, conforming perfectly to surface irregularities without distortion...

Micro Set, Setting Solution

Microscale's Micro-Set is a decal "setting" solution that softens decals and improves adhesion plus lets the decal conform to the model's surface. To apply Micro Set: Use a soft flat artist's brush and apply Micro Set where you are going to apply the...

Model Master Gelb RLM 04 Acrylic, 1/2oz Bottle

This can be thinned, in order to flow better, with an Acrylic Thinner.   By Testor's, one 1/2oz bottle.

Fenton/Anson Front Wheels 1/25

A pair of 5-slot Fenton (or Anson) front wheels. Popular on gassers, super stock or pro stock cars. These are similar to the Gasser Front Wheels, but these have larger slots  OD = .67", 17mm Overall Width = .19", 5mm   The wheels that will...

Wide Rear Steel Wheel Pair 1/25

A pair of deep rear wheels. These are stock looking steel wheels with lug nuts, except they're wide to hold big rubber. Great for street racers, early Super Stock or Pro Stock and Rat Rods. Width/Depth = .33" (11/32")   Contains 2 resin wheels by...

Dual Quad Tunnel Ram Manifold 1/25

Set a pair of Dominator or Demon carbs on top of this manifold. Make sure you have room under your hood or cut a hole in the hood to allow for the height. Overall height is .43" (7/16"). Here's a photo of a real dual quad setup byRich Vitiritti. ...