53 Ford Pickup with Race Hauler 1/25

This latest AMT release is full of features and includes two kits, two engines and optional items.   PICKUP TRUCK 1953 Ford Optional Custom grille, side pipes, bed cover and rear fendersOpening hoodFold down tailgateFlathead or Desoto HEMI...

1969 Yenko Camaro, 1/25

The initial 1967 release of the Chevrolet Camaro had these engine options: One of two straight 6-cylinder engines; Small-block in 302-, 327-, or 350-cubic-inch displacement; Big Block 396. The vaunted 427 was reserved for mid-size cars,...

Coil Over Shock Kit 1/16

Here is a complete, realistic appearing, coil over shock kit, with all of the parts needed to detail your suspension. They are static and once assembled are not movable. These coil-overs replicate 15" Penske 8300 double-adjustable...

426 HEMI Front Motor Plate, 1/16

A photo etched front motor plate for a Revell HEMI engine. Includes 4 chassis tabs for bolting on to the motor plate. Sized to fit an approximate chassis width of 1.16" (center to center). Will replace existing Revell kit mounts. For the best fit,...

RBS Square 4-Hole Hat with Butterflys, 1/16

This is a CAD designed replica of an RBS Square 4-Hole Injector Hat, in 1/16 scale. The intake openings are hollowed out. Small holes across the front openings are provided for a rod to connect the butterflys to your throttle linkage and barrel valve...

Front Strut Gusset Kit 1/16

These gussets are intended to add both structural as well as added detail to the upper strut mount. There are enough for approximately seven cars. These gussets are intended to fit around a 9/64" (.140)" diameter upper strut mount.    ...

Lamb Front Strut Suspension Kit 1/16

Here is a complete 1/16 scale Lamb Front Strut Kit, with all of the parts needed for a detailed front suspension. This is a static suspension and not functional. Kit includes: 2-piece 3D-printed, high detail strut bodies (brackets integral with...

Blower Belt, 1/16

This 1/16th scale ribbed blower belt fits Revell Hemi engines, as well as other engines, but the pulley cogs may be different.  It is cast out of urethane rubber and stretches enough to fit nicely over the kit pulley setup.  It can fit...

Blower Restraint Plate, 1/16

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers.   This photo etched piece is etched out of .016"...

Throttle Linkage Set, 1/25

A throttle linkage set with pins added to the ends of the linkage components. This will provide a more stable attachment point for linkage rods, etc. Depending on your attachment, the pin may have to be bent 90 degrees.   Photo etched...

Dana Rear End, Standard Width, Bare 1/25

Here is a Dana rear end in a standard width, molded in white resin. Overall length between axle tube ends is 2.25" The width can be shortened to suit your build by cutting the axle tubes. A Dana rear with the brake kit is available here.   See...

Stock Width 9" Rear End 1/25

Here is a nicely detailed 9" Ford OEM-style rear. This version is the stock width (2-1/4") and there is a narrowed width Ford 9" found here. This rear is also available with an included brake set and in either in black or white. The width can be...