1/25 - 1/24 Scale

Pro Stock/Pro Mod Wing 1/25

This wing has a small arch as viewed from the toop. Has teardrop end plates. Measurements: Overall length: 2.15" Width at end plates: .52" Contains 1 resin piece, 1/25 scale

American Trak Star Front Wheels 1/25

American Racing TrakStar Front Wheels  This is 5-bolt mounted, not spindle mounted. Brand new and I only have a limited quantity to start with. These American Racing front wheels match the Trak Star rear wheels.   Here's a  photo of...

Weld Delta 1 Rear Wheels 1/24

A pair of Weld Delta 1 rear wheels in 1/24 scale. These are one-piece CNC machined aluminum wheels. Includes: CNC Aluminum Rings PE Centers Instructions    PHOTO OF REAL DELTA 1 WHEEL WITH A BEADLOCK RING (not included) Wheel...

Blower Restraint Plate, 1/25

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers. This photo etched piece is etched out of .006" nickel-silver...

Pedals - Drag, Rat Rod, Hot Rod 1/25

A set of pedals, perfect for dragster, gasser, hot rod, rat rod or other project car. Nine sets of pedals are included. Each set has accelerator, brake and clutch pedals. Photo etched and assembly is required.   Photo etched sheet, by Highlight...

Big Block Ford, Crank Trigger 1/25

For that big block Ford engine to keep perfect ignition timing. Includes crank trigger wheel, sensor mount and adjustable sensor mounting bracket. A crank triggered ignition system can make more horsepower than a distributor triggered system. A crank...

Weld V-Series Rear Wheels 1/24

A pair of Weld V-Series rear wheels.Includes: Deep Outer Rims Inner and Outer Center Inserts Instructions Wheel dimensions:Width .730"Outside Diameter .730" Note the difference between the 1/24 version (left) and the 1/25 version (right) below...

Good Year Polyglas Tire Set of 4 1/25

A set of four Good Year Polyglas blackwall tires with white lettering on both sides. The tread detail is excellent. Two sizes are included - F60-15 for the front and L60-15 for the rear. These tires were popular during the '60's and '70's and are a...

Clutch Can HEMI 1/25

 Here is an item every race car needs and is required in almost all NHRA classes. This clutch will contain a clutch/flywheel explosion. This is a replica of a real world Trick Titanium clutch can and matches the bellhousing pattern on HEMI blocks...

Front Strut Kit for Aluminum Wheels, TBM Rotors 1/25

This is a complete 28 piece strut front end kit for 5-bolt wheels (a strut set for spindle wheels is found here. The nose of the 3D spindle is designed to center in Futurattraction's 5-bolt wheels and includes 3D-printed hubs to fit to the back...

Dana - Rear End & Brake Kit, Stock Width 1/25

Here is a complete Dana standard width rear end with brakes. The rear end and axle tubes are molded in resin. Overall length between axle tube ends is 2.25" A 'bare' Dana rear without the brake kit is available here. The product photo shows a white...

Pro Mod / Funny Car / Pro Stock Rear Wing 1/25

Includes main horizontal wing, sides and support rods. This wing can be made to fit many different race classes.   Here are some examples of what can be done.     Resin, 1/25 scale