Wheelie Bar Housing Kit 1/25

Great little wheelie bar kit! I was building a 1/25 scale 1963 Corvette as a Pro Mod drag race car, and naturally it didn't include wheelie bars, so I decided to build my own, but I wasn't sure where I was going to get the parts for the wheels, axle and brackets, until I ran across this little gem! I was very impressed by the quality of this kit. The problem that I had found was that you have to have great patience, and darn good eyes, as the parts are very, very small. You have to have very nimble fingers, and just take your time with it. I used 1/16" (1.6mm) Evergreen rod, part # 222 for the bars. Worked out beautifully!

They look good question do you have a video or paper showing how to assemble them that would be awesome. [Instructions are not available. Use a straight edge to fold both housings. Sandwich the PE wheels or use the solid 3D wheels. Telescoping rods are for the axle whose width can determine housing separation. Add .035" diameter rods for lower supports parallel to the ground and upper supports 45-degrees, attached to the chassis - Ted]

Looking for something to put on my Revell Tom Daniels Street Fighter 2 project which has been upgraded with a big block engine and wider slicks in the rear. This project just screams for some serious wheelie bars. I read a couple reviews of this product and I was impressed. I will scratch-build mounts to the car's frame as suggested in the product description.

My 1st time to build one of these came out PERFECT! Just take your time with it. I looked at many different online photos of the 1:1 setup I wanted to build. Then made a sketch of what I wanted & after a few hours “$$$$&”.