Shop by Manufacturer

Rear Tube Frame/Clip .800" Wide 1/25

A round-tube rear frame clip ready to install.  It's 3D printed in FUD material. Dimensions are:Frame width = .800"Frame tube diameter = .080"Cross member diameter = .080"Overall length = 2.55" Two other frame clips widths are available in .700"...

Louvers 3D 1/25 - 1/24

Louvers in 3D by Archer Surface Details. This is what you need for that Salt Lake racer, hot rod, rat rod or wherever you need to ventilate air. Use them at header welds and chassis welds These aren't decals.  They're 3D raised resin louvers that...

Louvers 3D 1/16 - 1/18

Louvers in 3D by Archer Surface Details. This is what you need for that Salt Lake racer, hot rod or wherever you need to ventilate air. These aren't decals.  They're 3D raised resin louvers that are cast onto Microscale clear decal film. ...

Weld Beads Perfect 3D 1/16

Weld beads in 3D by Archer Surface Details in two types of beads - Perfect and Arc. Use them wherever welds would be found, like: headers, intake manifolds/air boxes, frames, roll bars and the list goes on. The perfect-weld beads are machine generated...

Dzus Mounting Plates Lightweight 1/25

These light weight mounting plates, attach to the chassis or other structural member and provide an anchor point for the Dzus fasteners. See also Tpye 1 and Type 2 mounting plates for different configurations. They're individually mounted on a soft...

Dzus Mounting Plates Type 2 1/25

These standard, long mounting plates, attach to the chassis or other structural member and provide an anchor point for the Dzus fastener. See also the Type 1 shorter mounting plates or the Lightweight mounting plates. They're individually mounted on a...

Dzus Mounting Plates 1/25

These standard, short mounting plates, attach to the chassis or other structural member and provide an anchor point for the Dzus fastener. See also the Type 2 longer mounting plates or the Lightweight mounting plates. They're individually mounted on a...

Weld Beads 3D - Arc 1/25 - 1/24

Weld beads in 3D by Archer Surface Details. Use them wherever welds would be found, like: headers, intake manifolds/air boxes, frames, roll bars and the list goes on. These arc-weld beads are the typical hand-held welds you'd make yourself. ...

Al Unser Jr

Original art work by Norman Sterner. Hand signed drawing of Al Unser Jr measuring 14" x 17". Medium is either graphite & colored pencil, pastels, oil pastels, and sharpie markers on stoneheng, medium, and sketch type paper.  ...

Al Unser

Original art work by Norman Sterner. Hand signed drawing of Al Unser in his dirt car measuring 14" x 17". Medium is either graphite & colored pencil, pastels, oil pastels, and sharpie markers on stoneheng, medium, and sketch type paper...

Liberty Transmission 1/16

Liberty 5-speed clutchless transmission for Pro Stock or other race class up to 3000 HP. Scott, at Futurattraction, took the measurements right off of a real Liberty tranny.  You can't get more realistic than that.   Here's the transmission...

Coil Spring .375" x .125" (pair) 1/25

These springs are used on Fururattraction's Coil Over Shock kits, but can be used in any suspension system that requires the dimensions below. The ends are ground flat.    Total height is .375" Outside diameter is .125" Wire diameter...