Ferrule Fittings for Braided, Soft, Hard LInes -Silver

Product Description

Perfect for simulating compression or crimp-type end-of-line fittings on NOS lines, blower injector lines, Injector-hat injection lines or carb fittings.

Can also be used as radiator hose ends and carburetor 'boosters'.               

For blown engine injection lines, you'll need 16 for the injection hat and 16 for the blower manifold.   Quantity per pack is 8.

NOTE: ID sizes are 'tight' measurements and you may want to go up one size if you are at these measurements.

Here's a photo of silver ferrules on an aluminum line, braided line and rubber line (left to right).

NOTE: Prices vary according to size. (8 per pack for all)

Sizes are as follows (here are the aluminum lines,, rubber lines and braided lines as mentioned below):

Prices vary per size.

SIZE A1 - .023" ID 

SIZE A - .027" ID 

SIZE B - .030" ID

SIZE C1 - .035" ID

SIZE C - .039" ID 

SIZE D - .041" ID 

SIZE E - .046" ID 

SIZE F - .052" ID 

 SIZE G - .055" ID 

SIZE H - .075" ID 

SIZE I - .080" ID NOTE: Size I are aluminum fittings by Detail Master
                        

Each pack contains 8 silver ferrules, your choice of size.