Engine Related

Soft Line Hose .098, 2.5mm OD & Roll Bar Padding in 1/25

This a soft rubber tubing (hollow) that is easily configured to the space you have. It's able to bend at a fairly sharp angle without collapsing.  The hollow ends make it easy to attach to objects with a placement of a pin or stud they may already...

Big Block Chevy, Crank Trigger 1/25

Includes crank trigger wheel, sensor mount and adjustable sensor mounting bracket. A crank triggered ignition system can make more horsepower than a distributor triggered system. A crank triggered system can often make more power and produce more...

Oil Breathers (Open Element) 1/25

A pair of machined aluminum oil breathers with filter element material.Contains 2 machined aluminum round breathers per pack, by Pro Tech.

Engine Detailing Kit Plus #1, 1/25

An engine wiring and plumbing kit Consists of: Radiator hose, black Heater hose, black Black detailing wire (battery, ignition, etc) Red detailing wire (battery, ignition, etc) Two sizes of aluminum line  By Parts by Parks, 1/25 scale.

Pre-Wired Distributor, Red Cap, 90-Degree Boots 1/25

An authentic looking distributor with 90-degree black boots at the cap and 90-degree black boots at the spark plug end. Includes a nicely detailed cap, base and aluminum stem along with pre-assembled spark wires with boots 90-degree black boots are...

Soft Clear Line - Hose .059, 1.5mm OD Dia.

This a soft clear line is easily configured to the space you have. It's able to bend at a sharp angle without kinking.See Hex Fittings or Size H Ferrules for this clear line.This line line equals the following equivalent 1:1 size at each scale.1/25 scale...

Electric Fuel Pump & Filter 1/25

An electric fuel pump with a fuel filter similar to the MagnaFuel pump.     Here's a photo of the real thing     One resin piece, by Pro Tech, 1/25 scale.    

Velocity Stacks, 4bbl Carb 1/24-1/25

Really nice looking aluminum velocity stacks for that 4bbl carburetor. Pack contains 2 stacks, turned solid aluminum, so there's no seam. They are hollow, so you can see the carb butterflies. Outside diameter at the carburetor junction is 1/4", 6...

Spark Plug Wire Loom Set 1/25

A nice set of photo etched wire looms. Spreaders are in 2, 3 and 4-hole configurations. If using soft .020" (or smaller) rubber wires, use the looms as they are. If using solid wire, It is necessary to "clean up" the holes with a .020" bit so wires will...

Distributor, Black Cap, 90-Degree Boots 1/25

An authentic looking distributor with 90-degree black boots at the cap and straight black boots at the spark plug end. Includes a nicely detailed cap, base and aluminum stem along with pre-assembled spark wires with boots on one end. 90-degree black...

Soft Line - Hollow .066", 1.7mm OD x .039, 1mm ID

This is a soft rubber tubing (hollow) that is easily configured to the space you have. It's able to bend at a sharp angle without kinking or folding.See Hex Fittings sized at .080 for this soft line. This soft line equals the following equivalent 1:1...

Holley Dominator Carburetor (Pair) 1/25

A pair of nicely detailed Holly Dominator 4-bbl Carburetors. With single or dual carbs, you'll need a Fuel Junction Block (see ENGINE DETAILING). Also see the Braided Lines, Hard Lines, Soft Lines and Fittings along with the SMALL or LARGE 'T' fitting...