Shop by Manufacturer

Roll Cage/Chassis Gussets & Brackets 1/24-1/25

A photo-etched plate of miscellaneous pieces to reinforce your chassis, roll cage and other components. They can be painted  or left bare for that aluminum look.   By Detail Master, 1/24, 1/25 scale.    

Aluminum Hard Line .031, .79mm Dia

This aluminum hard line equals the following equivalent 1:1 size at each scale.1/25 scale = 11/16"1/16 scale = 7/16"1/12 scale = 5/16"1/8 scale = 3/16" Depending on your scale, typical uses are smaller fuel lines around the engine, oil lines, A/C and...

3D-Printed 'Street' 4bbl Carburetor 1/25

Highly detailed Holley Street 4-bbl Carburetor with a choke plate in the closed position.With single or dual carbs, you'll need a Fuel Junction Block (see 1/25 SCALE/ENGINE RELATED/FUEL MANAGEMENT). Also see the Braided Lines, Hard Lines, Soft Lines and...

4-Pulley Set, 2-Grooves, 1/25

A set of four spun aluminum V-groove pulleys. Consists of: 1 Double groove crank pulley 1 Double groove water pump pulley 1 Large single groove accessory pulley 1 Small single groove accessory pulley Belt material   NOTE: The diagrams on the...

Weld Beads 3D - Arc 1/25 - 1/24

Weld beads in 3D by Archer Surface Details. Use them wherever welds would be found, like: headers, intake manifolds/air boxes, frames, roll bars and the list goes on. These arc-weld beads are the typical hand-held welds you'd make yourself. ...

Throttle Linkage Set, 1/25

A throttle linkage set with pins added to the ends of the linkage components. This will provide a more stable attachment point for linkage rods, etc. Depending on your attachment, the pin may have to be bent 90 degrees.   Photo etched...

Automotive Manufacturer Decal Sheet, 1/25

This decal has to be seen to view all of the manufacturers on it ...Take a close look at the product photo above. It has sponsors are from racing equipment, oil, gasoline, tire, gas and many more manufacturers. Some of the Included...

Aluminum Gas Cap 1/16

Excellent detail for your race car fuel cell, hot rod Moon tank and other tanks like an oil tank on a Funny Car, Pro Mod or Dragster.Can also be used for a radiator cap, engine oil breather cap or other instance where a filler neck is required. Diameter...

Precision Perf Kwik-Shift Shifter Kit, 1/25

A realistic looking Kwik Shift shifter by Precision Performance Products. This is a manual shifter that is connected to the transmission linkage with a cable out of the bottom rear portion of the shifter. Because the shifter is typically mounted just...

Drag Racing Sponsor Decal Sheet, 1/25

This decal sheet has all of the drag racing manufacturers. The Sonny's, DART and Reher-Morrison decals will fit on your valve covers. Simpson will go on your parachute flag.   Some of the Included manufacturers: Sonny's MSD K&N Comp Cams...

Small Block Chevy Crank Trigger 1/25

Here is a Crank Trigger kit, for a small block engine and especially for the small block Chevy. Includes crank trigger wheel, sensor mount and adjustable sensor mounting bracket. A crank triggered ignition system can make more horsepower than a...

Racing Seat Belt, Harness, Hardware, Red Belt Material 1/25

Photo etched lap and harness seat belt hardware with red, textured belt material. One package will make 2 sets. Includes photo-etched buckles, harness material and directions.   By Gofer Racing, 1/24-1/25 scales.