1/25 - 1/24 Scale

Dual Plug HEMI Valve Covers 1/25

A pair of HEMI valve covers with dual spark plug holes already drilled. Contains 2 resin pieces.

Roll Cage/Chassis Gussets & Brackets 1/24-1/25

A photo-etched plate of miscellaneous pieces to reinforce your chassis, roll cage and other components. They can be painted  or left bare for that aluminum look.   By Detail Master, 1/24, 1/25 scale.    

3D-Printed 'Street' 4bbl Carburetor 1/25

Highly detailed Holley Street 4-bbl Carburetor with a choke plate in the closed position.With single or dual carbs, you'll need a Fuel Junction Block (see 1/25 SCALE/ENGINE RELATED/FUEL MANAGEMENT). Also see the Braided Lines, Hard Lines, Soft Lines and...

Engine Detailing Kit Plus #2, 1/25

An engine wiring and plumbing kit Consists of: Radiator hose, black Heater hose, red Black detailing wire (battery, ignition, etc) Red detailing wire (battery, ignition, etc) Two sizes of aluminum line  By Parts by Parks, 1/25 scale.

4-Pulley Set, 2-Grooves, 1/25

A set of four spun aluminum V-groove pulleys. Consists of: 1 Double groove crank pulley 1 Double groove water pump pulley 1 Large single groove accessory pulley 1 Small single groove accessory pulley Belt material   NOTE: The diagrams on the...

Weld Beads 3D - Arc 1/25 - 1/24

Weld beads in 3D by Archer Surface Details. Use them wherever welds would be found, like: headers, intake manifolds/air boxes, frames, roll bars and the list goes on. These arc-weld beads are the typical hand-held welds you'd make yourself. ...

Throttle Linkage Set, 1/25

A throttle linkage set with pins added to the ends of the linkage components. This will provide a more stable attachment point for linkage rods, etc. Depending on your attachment, the pin may have to be bent 90 degrees.   Photo etched...

Automotive Manufacturer Decal Sheet, 1/25

This decal has to be seen to view all of the manufacturers on it ...Take a close look at the product photo above. It has sponsors are from racing equipment, oil, gasoline, tire, gas and many more manufacturers. Some of the Included...

Drag Racing Sponsor Decal Sheet, 1/25

This decal sheet has all of the drag racing manufacturers. The Sonny's, DART and Reher-Morrison decals will fit on your valve covers. Simpson will go on your parachute flag.   Some of the Included manufacturers: Sonny's MSD K&N Comp Cams...

Small Block Chevy Crank Trigger 1/25

Here is a Crank Trigger kit, for a small block engine and especially for the small block Chevy. Includes crank trigger wheel, sensor mount and adjustable sensor mounting bracket. A crank triggered ignition system can make more horsepower than a...

Racing Seat Belt, Harness, Hardware, Red Belt Material 1/25

Photo etched lap and harness seat belt hardware with red, textured belt material. One package will make 2 sets. Includes photo-etched buckles, harness material and directions.   By Gofer Racing, 1/24-1/25 scales.

Flowmaster Mufflers, Pair 1/25

A pair of nicely made and realistic looking offset inlet/outlet mufflers. These are 3D-printed with FLOWMASTER in raised letters on one side. Two 3D-printed muffler clamps and a Flowmaster decal is included for each muffler. Mount the muffler upside...