1/16 Scale

Holley Dominator & PE Details, Pair 1/16

Holley Dominator Ultra Detail Carb Kit with Photo Etch Air Horn and Linkage Contains 2 carbs and PE details.   Photo shows completed carb and is for illustration only. Assembly required. Resin and photo etched parts by Futurattraction, 1/16...

12-Spoke Front Wheels 1/16

12-Spoke front drag racing wheels. 2 resin pieces, resin, 1/16 scale.

Big Block Engine Crank Trigger 1/16

Here is a Crank Trigger kit, for the a block engine and especially for the big block Chevy. Includes crank trigger wheel, sensor mount and adjustable sensor mounting bracket. A crank triggered ignition system can make more horsepower than a distributor...

Cragar Super Trick 8-hole Rear Wheels 1/16

Cragar Super Trick, 8-hole rear drag racing wheels. Fits Revell tires...

Injector Butterfly Set for Competition Resins Shotgun Hat 1/16

These Butterflies are finely detailed showing the cross shaft and screws holes for each butterfly disc. They are made to fit the Competition Resins 2-Hole Shotgun injector hat (part #148).  Click here to see the 1/16 injector hat...

Shotgun 2-Hole Injector Hat 1/16

Contains 1 'Shotgun' type 2-hole resin injector hat. See also, photo etched butterfly discs made for this injector.   Resin, 1/16 scale.

Louvers 3D 1/16 - 1/18

Louvers in 3D by Archer Surface Details. This is what you need for that Salt Lake racer, hot rod or wherever you need to ventilate air. These aren't decals.  They're 3D raised resin louvers that are cast onto Microscale clear decal film. ...

Dragster or Fuel Altered Front Tires 1/16

Skinny front tires for wire or spoked wheels, as found on dragsters and altered. Measurements: 1" OD 0.7" ID These tires fit the Comp Resins 12-spoke wheels found here. Contains 1 pair rubber-like tires.

Oval Fender Exhaust Bezels Pro Mod, etc 1/16

These bezels are designed to replicate the bezels used on modern Pro Mod and other cars where the exhaust exits the fender well, just behind the front wheel. These are oval, but round bezels are also available for a straight exhaust exit. Photo Etched,...

Ignition or General Wire, Red .014"

This deep red wire can be used for any electrical need. Scale Motorsport's wire is not as stiff as most other electrical wires. It is .014" diameter which is equal in real life to 5/16" or 9mm at 1/25 scale. At 1/16 scale, this wire would be equal to...

Tire Decal Sheet - Yellow Goodyear 1/16

1/16 scale decal sheet for slicks in yellow lettering.  White lettering is also available. Includes 'Goodyear', 'Eagle' and 'Goodyear Eagle' decals.  Enough for several cars.SLIXX Decals.One sheet. 1/16 scale.

Blower Restraint Plate, 1/16

This restraint plate sits under the blower and restraint straps would fasten to the slots and go over the blower to hold it down in the event it would blow up. It is universal to all blowers.   This photo etched piece is etched out of .016"...