Engine Parts & Detailing

Soft Line - Hose .157", 4mm OD & Roll Bar Padding in 1/16

This is a large, soft, rubber tubing (hollow) that is easily configured to the space you have. It's able to bend at a sharp angle without kinking or folding.I do not have Hex Fittings for this soft line. This soft line equals the following equivalent 1:1...

Soft Line - Hose .066", 1.7mm OD x .039, 1mm ID

This is a soft rubber tubing (hollow) that is easily configured to the space you have. It's able to bend at a sharp angle without kinking or folding.See Hex Fittings sized at .080 for this soft line. This soft line equals the following equivalent 1:1...

Brake or Fuel Line .016", .4mm Dia

  This hard line equals the following equivalent 1:1 size at each scale. 1/25 scale = 3/8"1/16 scale = 1/4"1/12 scale = 3/16"1/8 scale  =  1/8" Depending on your scale, typical uses are injector lines from distribution blocks into a...

Fuel or Brake Hard Line .020, .52mm Dia

This solid aluminum line is soft to bend and will not kink, even at tight angles. It straightens out easily and will conform to any shape you want.This aluminum 'hard' line equals the following equivalent 1:1 size at each scale.1/25 scale = 1/2"1/16...

Barry Grant DEMON 4bbl Carburetor 1/16

Detailed Barry Grant 4bbl CarburetorWith single or dual carbs, you'll need Pro Tech's 1/16 scale Fuel Junction Block.Also see the Braided Lines, Hard Lines, Soft Lines and Fittings along with the T fitting to split the fuel line to each carb. One...

Holley Dominator 4bbl Carburetor 1/16

Detailed Holly Dominator 4bbl CarburetorWith single or dual carbs, you'll need Pro Tech's Fuel Junction Block.Also see the Braided Lines, Hard Lines, Soft Lines and Fittings along with the T fitting to split the fuel line to each carb. One per...

Barrel Valve 1/16

A barrel valve is located on the left side of a supercharged engine injector hat. The fuel input is via a braided line from the fuel pump and 2 outlet braided lines go to 2 fuel junction blocks (see ENGINE DETAILING).Designed for Pro Tech .035 Braided...

Aluminum Oil Filter 1/16

Each package contains 1 filter. Machined aluminum  

MSD 7 Ignition Box 1/16

Each package contains 1 MSD 7 ignition box. See 'Detailing Wire, Small' to enhance this item.Resin 

MSD 6 Ignition Box 1/16

Each package contains 1 MSD 6 ignition box. The casting of this box shows the ribs and area for the MSD logo. The photo shows two Pro Tech MSD boxes with MSD labels copied from an automotive magazine and reduced. These are not included with the MSD 6...

Throttle Linkage 1/16

Whether it's a blown engine, injected or carbureted, these photoetched pieces will detail your throttle linkage. For the metal linkage that fit into the holes, use the .014 and .020 aluminum lines.  These are stiff enough to hold...

Rod Ends/Link/Heim Kit 1/16

Cast metal parts for your suspension or throttle linkage detail.  Can be used for heim joints/rod ends in suspension areas like a 4-link rear end, panard bar or front radius rods. Use in combination with Pro Tech's Throttle Linkage kit for a...