Shop by Manufacturer

Hex Braided Line Fittings .045

These hex fittings are compatible with the .045 diameter Braided Line, .040 Aluminum 'Hard' Line or .039 Soft Line    Make your own AN fittings using Pro Tech's aluminum Hex Fittings.For a realistic anodized appearance on these...

Soft Line - Hose .020", .5mm OD

This soft line equals the following equivalent 1:1 size at each scale.1/25 scale = 1/2"1/16 scale = 1/4" or 5/16"1/12 scale =1/4"1/8 scale  = 1/8"Typical uses are small oil, vacuum and fuel lines, especially fuel & nitrous delivery at the the...

Throttle Linkage Photo Etched 1/25

Photoetched pieces to detail your throttle linkage.Can also use some of the pieces for parallel spring shackles, brackets and other linkages. By Pro Tech.

Oil Breathers 1/25

A pair of machined aluminum oil breathers to mount on your valve covers. Contains 2 machined aluminum round breathers per pack, by Pro Tech.

Hood Pin Set 1/25

One-piece (pin and plate) hood pins that are photoetched. Contains 12 photoetched hood pins per pack, by Pro Tech.

Fuzzi Fur, Super Fine Flock, all scales

A really fine 'fur' flocking for carpets, floor mats, upholstery, etc. Use a diluted white glue (Elmer's), spray adhesive or wet paint and sprinkle the fur over the 'sticky' area. Can be packed down for a flatter look or left as sprinkled. Stored in a...

Blower Belts, Restraint Bags, Chutes & Chassis ID Decal Sheet 1/25

Here is a small sheet of decals specifically for labels on Blower Belts, Blower/Engine Restraint Bags, Parachutes and Chassis Identification.  It even has turbo charger vanes. Contains Diest and Stroud parachute logos and four "Remove Before...

Front Runner Tires 1/25

Front drag tire patterned after Goodyear Frontrunner style. Designed to be direct fit for R/M style drag front wheels. Dimensions: 1" OD.65" (21/32")  ID.25" wide Click here for a free downloadable sizing and fitment table for tires and wheels...

Spark Plug Boots 90Deg, 3D, 1/25

A package of ten, 90-degree, 3D-printed, spark plug boots, ideally suited for the distributor cap (see photo). Enough for eight spark plugs boots at the distributor, plus two boots for the coil wire.  You will need another set of boots for the...

Spark Plug Wire Looms, Photoetched 1/25

These wire looms will keep your spark plug wires separated. This will give you an organized look and it makes it easier to form your wires where you want them.  Used on all drag cars or street vehicles.There are enough wire looms here for many cars...

Drag Slicks, 14x32x15 1/25

These Drag Slicks equal a scale 14x32-15 tire.  The tread width equals 14" and the overall width, with sidewalls equals 18". To determine if these will fit your needs, here are the actual dimension:Width including Sidewall = .75"Tread Width = ...

Pre-Wired Distributor, Black Cap, Straight Boots 1/25

An authentic looking distributor with straight black boots at the cap and at the spark plug end. Includes a nicely detailed cap, base and aluminum stem.   Also includes a center coil wire which is indicated with its wire end bent over...