This kit represents the current heavy duty style of 4-link kits found on high horsepower Pro Mod drag cars.

Also included in this kit is anti-roll bar linkage and arms. No torsion bar/tube is included and must be scratch built.

Included are four .050" OD stainless steel tubes cut ~.75" length to permit customization, and eight formed-wire pieces which can be trimmed on end opposite of the hole.

Holes in all plates are intended to work with RB Motion (#1252) nuts and bolts pin sets. Hole cleanup with drill bit will be necessary.

This 4-linnk set fits the Dana rear end and brake kit and the standalone Dana rear end, both by Futurattraction

 These are modeled after real 1:1 brackets.                               Sketch of 4-Link Installation

Assembly required.

Photo etched plates are made from .010" nickel-silver, 1/25 scale.